BlyilyB 12-80V Dual Color Motorcycle Scooter Amber Color For Turn Signals and Red Color For Tail Light Brake Stop Light Lamp (Pack of 1)

Installed on a mini bike, works as it should and wiring was simple

Was very easy to install with the wire types labeled on the box. It functions perfectly and looks even better. Also super light weight. Love it so far for my Surron Ebike.

The media could not be loaded. The taillight looks great and works just as described.

There is a lot in this small package. Tail light. Brake light. And turn signals. Just be aware this all needs to be hard wired and switches must be supplied and installed for each function. A switch to turn the tail light (running light) on. A switch for the left turn signal. A switch for the right turn signal. and a switch (normally you can use your existing brake lever(s) if they include switches which activate your controller). So make sure you work the mounting locations for the switches and he wiring runs before investing in this light. Fortunately the "flasher" for the turn signals is included in the unit so you don't need to buy an additional flasher module. The wiring is straightforward and the connections are shown in the product description (although there are no instructions included with the light). The light is just a hair over 4.5 inches wide and 1.25 inches high. The light is mounted using two bolts which are attached to the back of the unit. You could probably come up with an alternative mounting plan if you don't want to drill holes in your bike. The illumination is bright and clear and can be seen from a good distance in the dark and adequate in daylight conditions.

Fit perfectly for my custom mini bike wiring was super easy to do and all explained in the diagram.

Wonderful sealed taillight.Bright and has a little sequence when you turn on the ignition.5 wires : Ground,tail ,break, blinker l & r

Have no issues with the light or it's other functions, for now it's the light on my motorcycle because I bobbed it out, this would work great on any bike, four wheeler, or anything else that needs only a single running/brake light in the rear, made my own bracket for it as the work I'm doing to my bike is all custom

This light does not require a a relay for blinkers to work just 12vTook the measurements on my bike mount and the light mounted perfectly into the factory location. I am only using it as a tail light but being a bicycle I did not need the others. The brake light would flash before illuminating which is a very useful feature for safety.