Noulei PLA 3D Printing Filament 1.75mm for 3D Printer 1kg/2.2lbs Spool (White)

I have printed over one hundred reels of PLA filament from different manufacturers and usually I use Noulei as I found them to be the most consistent in terms of the print quality outputted (to include the black filament I am currently reviewing). All four of the black Noulei filament I purchased from this seller were extremely brittle and broke apart in all four of the printers I loaded them in. Had to spend several hours taking apart the filament run-out sensors, extruders, bowden tubes, and hot ends to clean out all the small pieces that had broken apart.Wasted my day and wasted my money. Avoid this for your own good.To the seller, I would start asking serious questions about how you are storing the filament or looking into your own supplier. There is clearly something very wrong here.

The filament is great and prints perfect with my Ender 3 V2 I primarily use it for lithophane prints never had break-up as others are saying maybe because I use it also with a filament dryer set to 50degrees. Will order for more!

It’s not the worst filament I tried it started to break after using 200g. I tried PLA silk from this brand when there prices was 80 AED and they were fantastic for this one buy it if it’s cheap 80 AED or less otherwise it’s not worth it.Update after first quarter the filament started to break down easily only one print succeeded in the second quarter because I changed the filament with other brands after it break.If you are using printer with filament sensor it will break in locations that will not stop the printer.

This filament prints beautifully on a Creality Ender 3 Pro. But the filament is risked with cracks and twice has broken during a print and stopped feeding. This was a massive problem on overnight prints.However, the quality of the prints, when the filament doesn't break, is incredible! It could be that the filament was just old, but if this didn't break so often, I would easily give it 5 starsEDIT: If you keep the filament in a sealed bag after each print with silica gel for additional dryness, the cracks in the filament can be prevented. (now 4 stars up from 2 stars)

😍

If I don't pack it and keep it on printer, the filament going to the printer break. Also its a bit brittle due to long time storage at the warehouse

It kept breaking to pieces out of the boxes, tried pulling out some meters and it started to be more flexible, less than one calibration cube later, started breaking again

Filament is extremely stringy and brittle.

the filament keep breaking and when printing it is very wet and when print is done it is very week in compare to other non branded pla this is pure trash DO NOT BUY EXTREMELY BAD

Rapport qualité prix géniale. Quality un peu au dessus de la moyen . Mais pour le prix on est pas volé.

Wanted to try marble PLA for quite a while, and was very frustrated with many clogs. Fixed this by decreasing hotend temperature to 195°C, reducing retraction speed to 10 mm/s, and reducing retraction distance to 4 mm. Printed just fine after that.This material is particularly soft compared to other PLA, and I suspect this affects the temperature at which it can be printed.I had initially assumed the specks must be a different material leading to clogs. After some hours of trial and error, I found that actually my default hotend temperature of 200°C was too hot and causing problems.

its sealed and everything, but the line keeps breaking its not flexible enough I had to heat it with a hairdryer. i had better quality filament.

It works and does the job,but ain't as good as some other brands.