3D Touch Auto Bed Leveling Sensor Kit, MAKEASY Heat Bed Auto-Level Probe Module for 3D Printer Anet A8

Works well. Good repeatability.

If you want to spend your money on something that won't work then this is your item. It looks great, has all the cables you could need, but if you want repeatability, then this is not the probe for you! Same point being probe has a spread of .ooomm to .143, needless to say, it sucked for any type of bed leveling. Ended up using a micro switch and the repeatability was .01 to .016.

Works as advertised.

This product is cheap garbage, not only do you have to reflash the firmware on your printer, but i hope you own a soldering iron, Don't waste your money on this product, after 2 days of trying to get it to work , I'm going back to my old sensor because this one doesn't work with my Anet A8 like it claims, 20 bucks wasted!

Couldn't get it to work, and any forums where they talk about the black 3D Touch and everybody is trying to get it to work... nobody can figure it out.

It just does not work well, pin fell out. Does not always work. Replaced with a real BLtouch asolved everything

Didn't work out of the box.

We may be doing something wrong, but our BLTouch clone is constantly triggered despite any configuration changes we make. I'll update this review if we get it to work, but until then I would avoid this clone and buy the real BL Touch instead.